Skip to main content

Appliance MD Inc

SALES · SERVICE · REPAIR

Water Heater Repair

INTRODUCTION

Service Overview

Running out of hot water in the middle of a shower, or finding a puddle around your water heater, is a problem that can’t wait. Appliance MD Inc. provides fast, expert water heater repair for homes and businesses across Broward, Miami-Dade, and Palm Beach counties.

With more than 25 years of experience, our licensed, bonded, and insured technicians work on all makes and models, including electric, gas, tank, and tankless water heaters. We’ll find the cause, explain it clearly, and get your hot water flowing again. Service calls start as low as $95.

WHAT WE REPAIR

Common water heater problems we fix

No Hot Water

The tank or unit produces only cold water

Lukewarm Water

Water never gets hot enough, or runs out too fast

Leaking Tank

Water pooling around the base or dripping from fittings

Strange Noises

Popping, rumbling, or hissing from the tank

Pilot Won't Light

Gas unit won't ignite or keeps going out

Discolored Water

Rusty, brown, or smelly hot water

OUR PROMISE TO YOU

How It Works

01

Call or Book Online

Tell us what's going on with your system.

02

We Diagnose

A technician inspects the unit and finds the root cause.

03

Upfront Estimate

You get a clear price before any work starts.

04

Fixed Right

We complete the repair or install and make sure it's running properly.

WHERE WE WORK

Areas We Serve

Don't Wait for a Small Problem to Become a Big One.

Same-day appointments available across Florida call now for a fast, honest diagnosis.

QUICK ANSWERS

FAQs

How much does water heater repair cost?

The cost depends on the problem and the parts needed. Our service calls start as low as $95, and after we diagnose the issue you get an upfront estimate before any work begins.

On an electric heater, the usual causes are a tripped breaker, a burned-out heating element, or a faulty thermostat. On a gas heater, it’s often a pilot light that has gone out or a failed thermocouple. Check that the breaker hasn’t tripped, and if the problem continues, call us.

Leaks often come from loose fittings, a faulty pressure relief valve, or a corroded tank. A leak at a fitting or valve can usually be repaired, but a leak from the tank itself typically means it needs to be replaced. Turn off the power (or gas) and the water supply to the unit, then call us promptly to prevent water damage.

These sounds are usually caused by sediment that has built up at the bottom of the tank, which traps water underneath and makes it bubble as it heats. Flushing the tank can often fix it. If the noise continues, the heating element or tank may be wearing out.

If your heater is under about 8 to 10 years old and the problem is a part like an element, thermostat, or valve, repair is usually the better value. If it’s older, or the tank itself is leaking or corroded, replacement is usually the smarter choice. We’ll give you an honest recommendation either way.